Fanuc Symbol CAPi T Operators Manual

AUTOMATIC PROCESS
DETERMINATION FUNCTION
B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
652
(1)When the value in No.50 is smaller than the value in No.51
No.51(maximum
inner diameter
which can be ma-
chined with drills)
No.50 (minimum inner di-
ameter which can be ma-
chined with the inner sur-
face tool)
Fig. 7
When setting data Nos.50 and 51 are set as shown in Fig.7, the following
processes are created:
Process 01 Drilling
Drills area (1) in Fig.8.
Fig. 8
Checks setting data Nos.52 and 53 for the second area to be drilled.
Value in No.52 < d
Value in No.53 <
1
D
Fig. 9
No.52 (minimum allowance for drilling)
No.53 (minimum length–to–diameter ratio of the inner surface to be
drilled)

Leave a Reply

Your email address will not be published. Required fields are marked *