Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
657
Checks the conditions shown in Fig.12 for the third area to be drilled.
When the conditions in Fig.12 are satisfied
ã
Process 03 Drilling
Drills area (3) in Fig.26.
When the conditions in Fig.12 are not satisfied
ã
Drilling is not performed.
(4)When a value is set in No.51 but No.50 is undefined
No. 51 (minimum inner diameter
which can be machined with drills)
Fig.30
No.50 (minimum inner diameter which can be machined with the
inner surface tool): Undefined

Leave a Reply

Your email address will not be published. Required fields are marked *