Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
48
(e) DIRECTION DN =. . . . . .
(³: RIGHT ²: LEFT °: ABOVE ±: BELOW)
Designate the grooving direction by the arrow such as right (³),
left (²), above (°) or below (±) when the system asks you the above
question.
±±²
(f) After inputting the width and depth, the system asks you the figure
at groove corners. Numbers 1 to 4 area allocated to the corners of
each groove in the sequence of figure input.
(Example)
G
² ²
G
³ ³
Designate whether the figures of respective corners 1 to 4 are “round
(R)”, chamfered (C) or left unmachined according to the
following questions being displayed on the CRT screen.
R/C OF CORNER (ALONG ELEMENT)
1’ST KC = CV = Figure at the 1st corner. . . .
2’ND KC = CV = Figure at the 2nd corner. . . .
3’RD KC = CV = Figure at the 3rd corner. . . .
4’TH KC = CV = Figure at the 4th corner. . . .
D For rounding, depress
R
for KC = question, and input a radius
value for CV = question.
D For chamfering, depress
C
for KC = question, and input a
chamfering amount for CV = question.
D If a corner is neither rounded or chamfered, and it is left undone as
it is, depress
INPUT
key only, or depress [NEXT PAGE] key to
proceed to the next CRT screen when the system asks you the
question.
Trapezoid grooving (Automatic process determination function B is
required.)
As with grooving, to select trapezoid grooving, specify G.
(a) ON WHICH ELEMENT EE = Element on which a trapezoid. .
groove is made
(0: Last element, 1: Next element)

Leave a Reply

Your email address will not be published. Required fields are marked *