Fanuc Symbol CAPi T Operators Manual

AUTOMATIC PROCESS
DETERMINATION FUNCTION
B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
660
[Warnings and Note]
WARNING
1 Setting data No.52 (minimum allowance for drilling) and
No.53 (minimum length–to–diameter ratio of the inner
surface to be drilled) are effective for machining a diameter
greater than the value in setting data No.50 (minimum inner
diameter which can be machined with the inner surface tool)
and less than the value in setting data No.51 (maximum
inner diameter which can be machined with drills).
2 If setting data No.50 (minimum inner diameter which can be
machined with the inner surface tool) is set to a value larger
than that set in setting data No.51 (maximum inner diameter
which can be machined with drills), an uncut area may as
shown in Figs.21 and 22.
NOTE
If an uncut area remains after machining using a drill with a
tip, that area is not cut in later processes that are
automatically determined.
Not cut with automatic process determination
Fig.38

Leave a Reply

Your email address will not be published. Required fields are marked *