Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. DETAILS OF AUTOMATIC
PROCESS DETERMINATION
AND NOTES ON ITS USE
AUTOMATIC PROCESS
DETERMINATION FUNCTION
661
If the part figure is closed, the automatic process determination function
may not correctly operate.
Example 1)
When the start point of the part figure has a larger X coordinate than
the end surface
If the part figure starts from F, the outer surface
machining process is not correctly determined.
Example 2)
When the start point of the part figure is the same as the cutting–off
start point
If the part figure starts from the cuttingoff start point,
the cuttingoff process is not correctly determined.
4.8
AUTOMATIC
PROCESS
DETERMINATION
FOR A CLOSED
FIGURE

Leave a Reply

Your email address will not be published. Required fields are marked *