Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
DOUBLE SIDED MACHINING
667
The double side machining function enables to prepare two NC programs
by only one editing operation so that the front–side NC program has been
executed, and then the direction of blank is changed and then the
rear–side NC program is executed.
i. The definition of blank figure and part figure is same as the ordinary
way of standard system. When you do the work reversing, switch it
according to the parameter.
ii. The part figure is defined by the final part figure with the single stroke
drawing by using symbolic key.
iii. To rotate the part figure to X axis and to process the back side from the
front, the process definition and NC data preparation are done.
iv. Automatic processing decision can be used.
v. NC data output only of the front side or the back side can be done.

Leave a Reply

Your email address will not be published. Required fields are marked *