Fanuc Symbol CAPi T Operators Manual

DOUBLE SIDED MACHINING
B–63304EN/02
5. PROCESSING DEFINITION
676
The coordinate value of the point which the cursor shows displays the
coordinate value in the coordinate system of Secondary processing.
Fig.5.2.2
Do not specify the cutting area by stepping over the start and end points
of the part figure.
Example
For instance, the shaded portion cannot be specified for a cutting area
when the part figure started from “a” point.
Define the cutting condition by the same way of standard system.
5.2.2
Cutting Area Screen
5.2.3
Cutting Condition
Screen

Leave a Reply

Your email address will not be published. Required fields are marked *