Fanuc Symbol CAPi T Operators Manual

DOUBLE SIDED MACHINING
B–63304EN/02
5. PROCESSING DEFINITION
678
Specify the first and second processing areas using the cursor and arrow
keys on the MACHINING AREA DIVISION screen as same way as the
CUTTING AREA DEFINE screen. The arrows of °, ³, ±, ² can be
used on this screen.
Fig. 5.3.1 (b)
The position of DC1 becomes the starting point of the part figure
definition. The dividing direction of DC1 can be changed. However, the
position cannot be changed. DC2 can change both positions and
directions of division.
When the specifies dividing point as shown in Fig. 5.3.1 (b).
The area of the First processing and a Secondary processing will divided
as shown in Fig. 5.3.1 (c).
Secondary
processing
area
First
processing
area
Fig. 5.3.1 (c)
If the NEXT PAGE is pushed in Fig. 5.3.1 (b), the screen switches to
the PROCESS SETTING screen.

Leave a Reply

Your email address will not be published. Required fields are marked *