Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
50
When the above data is specified, a square groove is defined.
To define a trapezoid groove, specify the following data. To define a
conventional square groove, ignore the prompt and press the NEXT
PAGE soft key.
(f) WIDTH OF B. (1) W1 = Bottom width 1 of the groove. . . .
(This need not be specified if
bottom angle 1 of the groove is
specified.)
(g)WIDTH OF B. (2) W2 = Bottom width 2 of the groove. . . .
(This need not be specified if
bottom angle 2 of the groove is
specified.)
(h)ANGLE OF B. (1) A1 = Bottom angle 1 of the groove. . . .
(This need not be specified if
bottom width 1 of the groove is
specified.)
(i) ANGLE OF B. (2) A2 = Bottom angle 2 of the groove. . . .
(This need not be specified if
bottom width 2 of the groove is
specified.)
In figure definition, the system does not check the validity of the
specified bottom width (W*) and bottom angle (A*) of the groove.
The operator must carefully observe the figure drawn after the figure
is defined.
The positions of bottom widths 1 and 2 and angles 1 and 2 of the
groove depend on the direction of figure definition in the same way as
they do for R/C OF CORNER.

Leave a Reply

Your email address will not be published. Required fields are marked *