Fanuc Symbol CAPi T Operators Manual

DOUBLE SIDED MACHINING
B–63304EN/02
5. PROCESSING DEFINITION
680
i. Part figure definition and relation of DC1
Automatic processing decision judges that DC1 to DC2 in the
clockwise area for the First processing and DC2 to DC1 in the area for
Secondary processing.
Secondary
process
area
First
proces-
sing area
Fig. 5.3.4 (a)
It is necessary to specify start point on the drawing upper. At the part
figure definition to make the process without uselessness.
ii. Definition method of DC1 and DC2
The division as shown below cannot be defined.
EXAMPLE A.
The direction of division is same as that of element.
Fig. 5.3.4 (b)
5.3.4
Process Area Division

Leave a Reply

Your email address will not be published. Required fields are marked *