Fanuc Symbol CAPi T Operators Manual

DOUBLE SIDED MACHINING
B–63304EN/02
6. NC DATA PREPARATION
682
6
NC DATA PREPARATION
WARNING
Even when the tool path and machining processes
specified in NC data are verified by machining simulation or
tool path check, if the data relating to the actual tool offset
and workpiece shift is incorrect, the tool may collide with the
workpiece and/or machine, possibly causing damage to the
machine and/or tool itself, or injury to the user. Before
starting a production run, perform a dry run to ensure that
the tool will not collide with the workpiece or machine. For
example, specify a low feedrate, then start the NC program
without mounting a workpiece on the machine.
The distribution of the program number is as fouraxis lathe system.
(Odd number: First processing. Even number: Secondary processing)
After when the First processing (Fig. 6 (a)) ends, being drawn to the
material and the part figure again, animation on the Secondary processing
side will start. (Fig. 6 (b))
Fig. 6 (a) (First processing)

Leave a Reply

Your email address will not be published. Required fields are marked *