Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
10. RELATION WITH BACK–SIDE
MACHINING FAPT
DOUBLE SIDED MACHINING
687
10
RELATION WITH BACK–SIDE MACHINING FAPT
If the parameter settings are such that both workpiece reversing and
backward machining FAPT functions are selected, the workpiece
reversing function can be used, but the backward machining FAPT
function cannot. To enable the backward machining FAPT function, set
system parameter No. 104 to Do not use workpiece reversing.
Basically, a family program created using the backward machining FAPT
function cannot be used with the parameters set as stated above.
If this family program is used, define the machining processing newly.

Leave a Reply

Your email address will not be published. Required fields are marked *