Fanuc Symbol CAPi T Operators Manual

ANIMATED SIMULATION FUNCTION II
B–63304EN/02
3. OPERATION PROCEDURE
FOR ANIMATED SIMULATION
696
3
OPERATION PROCEDURE FOR ANIMATED SIMULATION
Select 6 from the main menu screen.
A blank is drawn on the screen. The blank is automatically scaled up or
down such that the entire figure can be safely displayed on the screen.
NOTE
When the value of system parameter 750 is 1, the blank is
displayed in the full screen.
As blank data, data for D and L input from menu 1, SELECTION OF
MATERIAL & SETTING OF BLANK SIZE is used.
(1)Adjust machine conditions.
D Set the coordinate system so that the correct workpiece coordinate
of a tool can be given when starting the program. Alternatively,
move the tool to the start point of the program.
D Search for the beginning of the NC program.
D Set machine lock mode.
(2)Press the [CHECK START] soft key.
“START” is displayed at the bottom right of the screen.
(3)Start NC operation.
When a T code is issued, an image of the tool is displayed and the user
can view a blank being cut.

Leave a Reply

Your email address will not be published. Required fields are marked *