Fanuc Symbol CAPi T Operators Manual

ANIMATED SIMULATION FUNCTION II
B–63304EN/02
4. ANIMATED SIMULATION
SCREENS
698
(1)When menu 6 is selected, a blank viewed on the XZ plane is drawn.
Drawing based on the XC plane is not performed.
(2)Either the interference check function or tool path plotting function is
enabled. To use the interference check function, the [INTER CHECK]
soft key must be set to on before executing animated simulation.
(3)This screen is used only for drawing animated simulation of turning.
When C or Yaxis animated simulation begins, this screen is
switched to another screen.
(4)Up to 128 turning tools, can be used for the animated simulation of
turning.
(5)The maximum tool number usable in the animated simulation of
turning is 255.
4.1
ANIMATED
SIMULATION OF
TURNING

Leave a Reply

Your email address will not be published. Required fields are marked *