Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. ANIMATED SIMULATION
SCREENS
ANIMATED SIMULATION FUNCTION II
699
(1)When gradation is set to on with the parameter screen, animated
simulation with gradation is performed. Only drawing based on the
XZ plane is performed.
(Valid only for a singlepath lathe)
(2)Half of the blank is drawn with gradation and the other half is filled
in.
(When the drawing format is reversed, the display is reversed.)
(3)For drawing with gradation, the drawn image cannot be enlarged or
shrunk, and the tool path display is disabled.
(4)Drawing with gradation is enabled for a bar, tube, and special blank.
(5)When the [INTER CHECK] soft key has been set to on before
executing animated simulation, an interference check is performed
during animated simulation.
(6)This screen is used only for drawing animated simulation of turning.
When C or Yaxis animated simulation begins, this screen is
switched to another screen.
4.2
ANIMATED
SIMULATION WITH
GRADATION

Leave a Reply

Your email address will not be published. Required fields are marked *