Fanuc Symbol CAPi T Operators Manual

ANIMATED SIMULATION FUNCTION II
B–63304EN/02
4. ANIMATED SIMULATION
SCREENS
700
(1)After executing an M code set in system parameter No. 741, executing
the tool selection T code switches to the Caxis machining screen.
(For cylindrical grooving, an M code set in system parameter No. 742
is referenced.)
This screen is displayed in the same way for animated simulation with
gradation.
(2)The right half of the screen is used to display Caxis cylindrical
grooving, the lower left quarter is used to display Caxis end face
machining and Caxis side face machining other than cylindrical
grooving, and the upper left quarter is used for three–dimensional
display.
(3)Cutting is represented with a filledin cross section (a circle) of the
tool tip. Rapid traverse drawing is represented with a dotted line,
regardless of whether the tool path is set to on or off.
(4)Even when a portraitmode lathe is being used, drawing is displayed
in landscape mode.
(5)Up to 32 milling tools can be used in Caxis animated simulation
(including those for Yaxis animated simulation). The maximum
usable tool number is 127.
4.3
C–AXIS ANIMATED
SIMULATION

Leave a Reply

Your email address will not be published. Required fields are marked *