Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. ANIMATED SIMULATION
SCREENS
ANIMATED SIMULATION FUNCTION II
701
(1)After executing an M code set in system parameter No. 741, executing
the tool selection T code causes switching to the Yaxis machining
screen. This screen is displayed in the same way for animated
simulation with gradation.
(Y–axis side face drawing is updated when the phase angle is
changed.)
(2)The right half of the screen is used to display Yaxis side face
machining, the lower left quarter is used to display Yaxis end face
machining, and the upper left quarter is used to display
three–dimensional line drawing.
(3)For Yaxis side face machining, the screen is further divided into four
pieces. Each time the phase angle is updated, machining display is
scrolled.
(The latest machining result is always displayed at the bottom of the
screen.)
(4)Cutting is represented with a filledin cross section of the tool tip.
Rapid traverse drawing is represented with a dotted line, regardless of
whether the tool path is set to on or off.
(5)Up to 32 milling tools can be used in Yaxis animated simulation
(including those for Caxis animated simulation). The maximum
usable tool number is 127.
4.4
Y–AXIS ANIMATED
SIMULATION

Leave a Reply

Your email address will not be published. Required fields are marked *