Fanuc Symbol CAPi T Operators Manual

ANIMATED SIMULATION FUNCTION II
B–63304EN/02
4. ANIMATED SIMULATION
SCREENS
702
(1)The interference check is performed only while animated simulation
of turning is being executed.
(2)If a tool tip and a chuck or tailstock interfere with each other during
simulation, an interference alarm is issued.
(3)Set the interference check to on or off with the [INTER CHECK] soft
key before executing animated simulation. This soft key is
automatically locked when animated simulation starts. When the
interference check is set to on, the [TOOL PATH] soft key is
automatically set to off and locked even if it has been set to on.
4.5
INTERFERENCE
CHECK FUNCTION

Leave a Reply

Your email address will not be published. Required fields are marked *