Fanuc Symbol CAPi T Operators Manual

ANIMATED SIMULATION FUNCTION II
B–63304EN/02
4. ANIMATED SIMULATION
SCREENS
704
The following soft keys are displayed on the animated simulation screen.
When gradation is turned off
CHECK ORIGI- PARAM- TOOL DRAWING INTER END
START NAL ETER PATH RANGE CHECK
When gradation is turned on
CHECK ORIGI- ROTATE AROUND SECTI- PARAM- INTER END
START NAL ON ETER CHECK
[CHECK START] Starts the animated simulation function.. . . . . . .
[ORIGINAL] Restores the blank to the pre–machining. . . . . . . . . . .
figure.
[PARAMETER] Enables to set parameters related to. . . . . . . . .
animated simulation.
[TOOL PATH] Enables or disables the tool path display.. . . . . . . . . .
[DRAWING RANGE] Enlarges or shrinks a figure.. . . .
[INTER CHECK] Enables or disables the interference check. . . . . . .
function.
(This key is not displayed when bit 5 of
system parameter No. 701 is set to 0 so that
the interference check is not performed.)
[END] Returns to the main menu screen.. . . . . . . . . . . . . . . . .
[ROTATE] Rotates a figure.. . . . . . . . . . . . .
[AROUND] Applies gradation to an entire figure.. . . . . . . . . . . .
[SECTION] Applies gradation to half of a figure and. . . . . . . . . . . .
draws a cross section of the other half of the
figure.
NOTE
1 The [ROTATE], [AROUND], and [SECTION] soft keys are
disabled during C or Yaxis animated simulation.
2 Animated simulation is possible for 128 tools counted from
the beginning of the tooling information. No animated
simulation is possible for any more tools.
4.7
SOFT KEYS

Leave a Reply

Your email address will not be published. Required fields are marked *