Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
5. SYSTEM PARAMETERSANIMATED SIMULATION FUNCTION II
705
5
SYSTEM PARAMETERS
System parameters used for animated simulation are as listed below.
These system parameters are used to set M codes for switching between
animated simulation mode for turning and animation simulation mode for
C– or Yaxis machining.
By specifying the M codes that are set using these parameters, before the
tool change command in the NC program, animated simulation mode can
be switched automatically.
No. Format Initial value Description
740 Integer Undefined Value of the M code for turning (NOTE)
741 Integer Undefined Value of the M code for Caxis machining
excluding cylindrical grooving (for switching
to the Caxis animated simulation screen)
742 Integer Undefined Value of the M code for cylindrical grooving
(for switching to the animated simulation
screen for cylindrical grooving)
743 Integer Undefined Value of the M code for Yaxis machining (for
switching to the Yaxis animated simulation
screen)
771 Character Undefined Axis name list (must be set when Y–axis
animated simulation is performed)
NOTE
The setting of this parameter can be omitted when only
turning is performed. However, it cannot be omitted when
turning is performed after C or Yaxis machining.

Leave a Reply

Your email address will not be published. Required fields are marked *