Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
6. SUPPLEMENTANIMATED SIMULATION FUNCTION II
707
MTF
Parameter No. Description Remarks
2220 Start of Caxis center drilling Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2221 Start of Caxis drilling Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2222 Start of Caxis tapping Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2223 Start of Caxis grooving Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2224 Start of Caxis notching Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2225 Start of Caxis cylindrical grooving Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2230 End of Caxis center drilling Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2231 End of Caxis drilling Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2232 End of Caxis tapping Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2233 End of Caxis grooving Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2234 End of Caxis notching Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2235 End of Caxis cylindrical grooving Only for 16TC CAP II, 16iTA CAP II, and Symbol CAPi T
2070 Start of Yaxis process
2071 Start of Yaxis center drilling
2072 Start of Yaxis drilling
2073 Start of Yaxis tapping
2074 Start of Yaxis grooving/pocketing
2075 Start of Yaxis optional figure
(2)Drawing of a tool tip figure using animated simulation is performed
within a rectangle having the following size:
Vertical size: approximately 45 mm
Horizontal size:approximately 36 mm
(3)If two or more of the following conditions overlap, animated
simulation may not follow the operation of the NC program.
D Simultaneous machining has been performed using balance cut.
D The holder displayed on the screen is too large.
D An extremely high feedrate is set for NC program operation.
In this case, the following symptoms can be observed.
D The tool path is not displayed correctly.
D Part of a figure can not be cut.
In such cases, correct the setting as follows:
D Make the size of the holder figure smaller.
D Scale down the drawing.
D Make the feedrate in the NC program operation slower.

Leave a Reply

Your email address will not be published. Required fields are marked *