Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
53
Machine figure input before is drawn again on the CRT screen and the
message SELECT SOFT KEY is displayed at the lower side of
screen.
Check to see if there is any mistake in the input of figure by comparing
the drawing figure with that drawn on the screen. Press a software key
depending on the status at that time.
Meaning of software keys
[ESCAPE] It is used to return to the menu screen.. . . . . . . . . . .
[BACK PAGE] It is used to return to the previous screen. . . . . . .
(drawing and blank screen).
[CORR.&ERASE] It is used to delete the machined figure. . . .
drawn on the screen and ERASE to modify
the machined figure. The modification
method is described below.
[CORRECTION] It is used to modify the machined figure. . . . .
based on the machined figure drawn on the
screen. The modification method is the
same as CORR. & ERASE”.
[NEW] It is used to delete the machined figure on. . . . . . . . . . . . . .
the screen and to input the figure again. All
elements input previously are deleted.
[LIST MODE] It is used to display all data previously. . . . . . .
input. Modification can be performed
similarly as in “CORRECTION”.
[DRAWNG RANGE] It is used to perform enlargement and. .
reduction of drawing. See Chapter 3 1–3”
for the details.
[CHAMFER] It is used to insert the chamfer figure into all. . . . . . . .
of angles of machined figure drawn on the
screen. The details are described in the
following.
[C–AXIS MENU] It is displayed when the C axis FAPT. . . . .
function option is available.
[Y–AXIS MENU] Displayed when the Yaxis FAPT function. . . . .
is provided.
[NEXT PAGE] It is used to move to the next page if there. . . . . . .
is no part modified.

Leave a Reply

Your email address will not be published. Required fields are marked *