Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. ANIMATED SIMULATION
FUNCTION B
ANIMATED SIMULATION FUNCTION B
715
C–axis side drilling
During turning simulation, following interference is being monitored.
And if interference is detected, alam is indicated on the screen.
1) Interference between tool and chuck or tailstock.
2) Interference between tools of turret 1 and turret 2. (In case of two path
lathe simulation)
Interference is not checked during rapid traverse movement.
Direction of Xaxis in the XZ side view is determined in accordance
with the setting of the Drawing Format. Upward direction of Xaxis in
the XC front view always corresponds to the positive direction of
X–axsis, regardless of the setting of the Drawing Format.
In case of simulating 2paths lathe, machining processes are simulated on
the screen as follows.
In the XZ side view, tools of both turret 1 and turret 2 are drawn for both
turning and Caxis machining simulation. If simultaneous cutting by
both turret 1 and turret 2 tools, which can be programmed for only turning
process, is simulated, both turret 1 and turret 2 tools in this view move
simultaneously.
In the XC front view, the motion of either one of the tools which is now
cutting the workpiece is simulated as described in section 2.1.5, only
while Caxis machining process. While turning process, no tool motion
is simulated in this view.
Refer to section 2.3, System Parameter, for the position of the turrets
which are drawn on the screen during the simulation.
1.1.6
Interference Check
1.1.7
Drawing Format
1.1.8
Simulation of 2–Paths
Lathe

Leave a Reply

Your email address will not be published. Required fields are marked *