Fanuc Symbol CAPi T Operators Manual

ANIMATED SIMULATION FUNCTION B
B–63304EN/02
1. ANIMATED SIMULATION
FUNCTION B
716
By setting appropriate value in the parameter DRAWING TYPE C =”,
which is included in the PARAMETER SETwindow of the animated
simulation, the simulation picture can be selected as follows.
C=1: Draw XZ side view on left side and XC front view on right side
of the screen
=0: Draw XZ side view on full screen
Following softkeys are available for animated simulation.
CHECK
START
ORIGI-
NAL
PARAM-
ETER
TOOL
PATH
DRAWNG
RANGE
INTER.
CHECK
END
[CHECK START]
Press to start animated simulation.
[ORIGINAL]
Press to restore blank workpiece figure on the screen.
[PARAMETER]
press to set various parameters relating to the animated simulation.
[DRAWNG RANGE]
Press to increase or reduce the size of the simulation picture on the screen.
This softkey is not valid and not shown on the screen when simulation
views of both side view and front view are displayed on the screen.
Also, because this softkey is valid only before the CHECK START
soft–key is pressed and it disappears from the screen when “CHECK
START” is pressed, this softkey must be operated before pressing
CHECK START key if magnification or reduction is required.
[TOOL PATH]
Each time this key is pressed, the tool path tracing mode alternates
between ON and OFF.
When ON, tool path traces are drawn on both side view and front view of
the simulation. Tool path tracing mode can be alternated during the
simulation.
While in the interference check mode, the tool path traces are not drawn.
[INTER.CHECK]
Each time this key is pressed, the interference check mode alternates
between ON and OFF. This softkey disappears when bit 5 of the system
parameter No. 701 is ON(disable interference check).
When the interference check mode is switched ON, tool path tracing mode
is forced to be OFF.
The interference check mode can be changed only before the “CHECK
START”soft–key is pressed. After the key is pressed, pressing
“INTERFERENCE” softkey does not change the state of the
interference check mode.
[END]
Press to return to the Main Menu.
1.2
OPERATION
1.2.1
Drawing Type
1.2.2
Soft–Key

Leave a Reply

Your email address will not be published. Required fields are marked *