Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
54
When bit 1 of system parameter 19 is set to 1, the figure is displayed
vertically.
(3)Changing the color of a part figure or blank figure when it is modified
When a part figure or blank figure is modified (or created), the
elements before and after the element on which the cursor is placed are
displayed in different colors. As a result, the operator can easily tell
which element is currently being modified on the drawing.
System parameter 552 specifies the color of elements already
determined and system parameter 586 specifies the color of elements
to be determined.
Parameter No. Value Color Description
552 1 Red Specifies color of elements already
determined
586 3 Yellow Specifies color of elements to be
determined
Color Red Green Yellow Blue Purple
Light
blue
White
Value 1 2 3 4 5 6 7
NOTE
1 If the GRAPH MODE soft key is pressed after modification
of an original figure has been started by pressing the
CORRECTION soft key, the original figure cannot be
re–drawn.
2 If the ELEMENT BACK soft key is pressed in a definition
mode in which the end point of the previous element is
determined by the current element, the element before
these two elements is also drawn in the color of the
elements to be determined.

Leave a Reply

Your email address will not be published. Required fields are marked *