Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. SYSTEM PARAMETERS
Symbol CAPi T
739
Parameter
No.
Details
Standard
value
Coloring
data type
692 Character 7 Data entered on the animation screen for menu Nos. 5 and 6 (characters
entered on the entry line at the bottom)
693 Character 5 Prompt message and message on line 2 of the animation screen for menu Nos.
5 and 6
694 Character 7 Prompt data in a prompt on the animation screen for menu Nos. 5 and 6
695 Character 6 Numeric data on the animation screen for menu Nos. 5 and 6
696 Character 7 T code display character ”T” on the animation screen for menu Nos. 5 and 6
697 Character 11 Background color for title displays
698 Character 3 Background color for the prompt input window
699 Character 4 Background color for soft key and NC status displays
Number Type Initial value Description Remarks
0801 0.1
Specification
(eight pieces)
00000000
Bit 0 Screen display mode
0 : Background color mode
1 : Plain mode
Bit 1 Coloring data selection method
0 : Cannot be selected on the initial screen
1 : Can be selected on the initial screen
Note) If you change the screen display mode, press soft key
[SAVE END] on the setting screen and switch the power
off and on again.
7 6 5 4 3 2 1
0
0
0
Bit
New
NOTE
1 If the following NC functions are used, and switching occurs
to the NC screen, it becomes impossible to restore the
previous graphics drawing correctly.
D Servo waveform diagnosis function
D Graphics drawing function
D Dynamic graphics drawing function
D C executor
2 Set both bit 0 of system parameter No. 810 and bit 7 of NC
parameter No. 3119 to 1, or reset both to 0.

Leave a Reply

Your email address will not be published. Required fields are marked *