Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. CAP II FOR TWOPATH
LATHE WITH TWO
OPPOSING SPINDLES
CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
745
Define the base line position for the secondary cutting process, ZP2, as
well as the base line position for the primary cutting process, ZP.
X2
X
D
Z
L
ZP2 ZP
NOTE
This figure describes the case in Drawing Format 2.
BASE LINE ZP =. . . . . . . . .
BASE LINE 2 ZP2=. . . . . . .
BASE LINE (ZP) : Specify the distance between the base line of the
primary spindle side coordinate system and the
end face of the blank.
BASE LINE 2 (ZP2) : Specify the distance between the base line of the
secondary spindle side coordinate system and
the end face of the blank.
(1)Part Figure for turning process
Just define the whole finished part figure in the same manner as the
conventional CAP II for 1path or 2path lathe. There is no need to
distinguish the portion, which is machined in the primary cutting
process, from the portion, which is machined in the secondary cutting
process.
1.2
OPERATING
INSTRUCTIONS
1.2.1
Definition of Blank
Figure
1.2.2
Definition of Part
Figure

Leave a Reply

Your email address will not be published. Required fields are marked *