Fanuc Symbol CAPi T Operators Manual

CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
B–63304EN/02
1. CAP II FOR TWO–PATH
LATHE WITH TWO
OPPOSING SPINDLES
746
(2)Part Figure for C axis machining
When defining figures for end face hole, end face groove and face
milling, you are prompted to select the plane, which those figures are
defined on, from one of FRONT FACE or REAR FACE. Refer to
chapter X. BACK MACHINING FAPT, section 2.1.2 Part figure
input, item (2) Part figure input for C axis machining, of the
CONVERSATIONAL AUTOMATIC PROGRAMMING
FUNCTION FOR LATHE, OPERATORs MANUAL,
B–61804E–2/04.
Specify the coordinates of the home position (DXH,ZH) and the turret
index position (DXI,ZI) for the primary turret and the secondary turret.
ZH,ZI
DXH,DXI
Primary Spindle
Secondary Spindle
Primary Turret
Secondary Turret
ZH,ZI
DXH,DXI
TURRET NO. = 1 TURRET NO. = 2
HOME POSITION HOME POSITION 2
DXH = DXH =
ZH = ZH =
INDEX POSITION INDEX POSITION 2
DXI = DXI =
ZI = ZI =
Coordinates of the home position and the turret index position for primary
and secondary turret should be specified in each corresponding coordinate
system.
These coordinate values can be registered in the following system
parameters as a default value.
1.2.3
Home Position and
Turret Index Position

Leave a Reply

Your email address will not be published. Required fields are marked *