Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. CAP II FOR TWOPATH
LATHE WITH TWO
OPPOSING SPINDLES
CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
747
Primary Turret System Parameter No.
Machine home position (X value) : No.206
Machine home position (Z value) : No.207
Turret index position (X value) : No.210
Turret index position (Z value) : No.211
Secondary Turret
Machine home position (X value) : No.216
Machine home position (Z value) : No.217
Turret index position (X value) : No.220
Turret index position (Z value) : No.221
(1)Machining type selection
Following machining types are available. Use Sub Cycle and create
appropriate macrocall command to realize work conveying process
from the primary spindle to the secondary spindle.
Available machining types.
a. CENTER DRILLING b. DRILLING c. REAMING
d. TAPPING e. BAR FEED f. CUTTING OFF
g. ROUGHING OF OUTER FIG. h. SEMIFINISHING OF OUTER FIG. i. FINISHING OF OUTER FIG.
j. ROUGHING OF INNER FIG. k. SEMIFINISHING OF INNER FIG. l. FINISHING OF INNER FIG.
m. GROOVING OR NECKING n. ROUGHING OF GROOVE o. FINISHING OF GROOVE
p. THREADING q. CAXIS CENTER DRILLING r. CAXIS DRILLING
s. C–AXIS TAPPING t. CAXIS GROOVING u. CAXIS FACE MILLING
v. CAXIS SIDE MILLING w. SUB CYCLE
Among these machining types, BAR FEED and CUTTING OFF can
be specified only for the primary machining process.
Define the sequence of the machining steps as follows in the “KINDS
OF MACHINING window.
(1)Primary machining process
(2)Sub Cycle (Work conveying process)
(3)Secondary machining process
D Whether a machining step belongs to the primary machining process
or the secondary machining process is determined by selecting the
turret number in the tool data setting window, described later.
D The Sub Cycle for work conveying process must be defined in
between the primary process and the secondary process.
(2)Tool Data
(a) Turret Selection
Select turret number to determine which machining process,
primary or secondary, the machining steps specified in the “KINDS
OF MACHINING window belong to.
TURRET NO. TL =. . . . . . . . . . .
TOOL SELECT NO. TN =. . . . . .
TOOL OFFSET NO. TM =. . . . .
TOOL ID. NO. ID =. . . . . . . . . . .
1.2.4
Machining Definition

Leave a Reply

Your email address will not be published. Required fields are marked *