Fanuc Symbol CAPi T Operators Manual

CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
B–63304EN/02
1. CAP II FOR TWO–PATH
LATHE WITH TWO
OPPOSING SPINDLES
748
D Set as TL = 1 to specify the current machining step to be the
primary machining process. Set as TL = 2 to specify it to be
the secondary machining process.
(b)Setting Tool Data for Turning process
D Set the tool data for the primary machining process referring to
the figures below noted as Primary Turret”.
D Set the tool data for the secondary machining process referring
to the figures below noted as Secondary Turret”.
Following tool figures are the examples in case drawing format 1
or 2 for lateral lathe is selected.
1) Center drilling/ Drilling
+DD
+AN
+DD
+AN
Primary Turret
Secondary Turret
AS = 180
AS = 0
2) OD Cutting
Normal tool
Cutting direction
Primary Turret Secondary Turret
AS=–90
AC–
AN–
XN+
ZN–
AC+
AN+
AS=–90
XN+
ZN+
Cutting direction
RN+
RN+

Leave a Reply

Your email address will not be published. Required fields are marked *