Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
57
(Deletion example) Depress
DEL
key
When depressing
DEL
with
½
³ ½ ³
. .
Flickering
When depressing
DEL
with
½
G
³ ±
G
³ ±
. .
Flickering
(Exchange)
For exchanging figure symbols, (1) delete old one after inserting new one,
or (2) insert new one after deleting old one.
(4)
Change of numerical value
The system will ask you necessary numerical values after figure
element symbols have been input. If a numerical value was input by
mistake, a correct numerical value can be input again after moving the
question place by depressing [CURSOR ±] or [CURSOR °] CURSOR
key.
Select an optional question, and input a correct numerical value again.
[CURSOR ±] Element advances. . .
[CURSOR °] Element retreats. . .
NOTE
If a figure element of data was corrected, press the software
key “END”.
(1)Input of blank figure
If a special figure is selected as the blank figure (BF = 3) and surplus
thicknesses (TX, TZ) are not defined as shown below, the blank figure
input screen is displayed after the data of the machining profile is
entered.
3.2.4
Blank Figure Input of
Special Figure Blank

Leave a Reply

Your email address will not be published. Required fields are marked *