Fanuc Symbol CAPi T Operators Manual

CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
B–63304EN/02
1. CAP II FOR TWO–PATH
LATHE WITH TWO
OPPOSING SPINDLES
754
6) End Face Grooving
ZN–
AS = 0
WN+
XN+
Cutting direction
WN+
ZN+
AC+
AS = 180
XN+
Primary Turret
Secondary Turret
Cutting direction
AN–
AC–
AN+
RN+
RN+
ZN+
AS = 0
WN+
XN+
Cutting direction
WN+
Cutting direction
ZN–
AC–
AS = 180
XN+
AN+
AC+
AN–
Primary Turret
Secondary Turret
RN+
RN+
7) OD Necking
Primary Turret
Specify 135 degrees as tool mounting angle (AS) for OD
grooving or end face grooving tool.
Secondary Turret
Specify 45 degrees as tool mounting angle (AS) for OD
grooving or end face grooving tool.
8) ID Necking
Primary Turret
Specify 135 degrees as tool mounting angle (AS) for ID
grooving and 135 degrees for end face grooving tool.
Secondary Turret
Specify 45 degrees as tool mounting angle (AS) for ID
grooving and 45 degrees for end face grooving tool.

Leave a Reply

Your email address will not be published. Required fields are marked *