Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. CAP II FOR TWOPATH
LATHE WITH TWO
OPPOSING SPINDLES
CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
759
D Method for creating NC data is the same as that of conventional CAP
II for 1path or 2path lathe.
D Primary machining NC data is stored in the main part program
memory of the CNC and secondary machining NC data in the sub part
program memory of the CNC.
D Primary machining NC data is created in the primary coordinate
system and secondary machining NC data in the secondary coordinate
system.
D With Extended Sub Cycle Function option, identical sub cycle process
commands can be output on both primary and secondary machining
NC data by setting “0” for the TURRET No. (TL = 0) in the SUB
CYCLE window.
D For other details, refer to chapter III. PROGRAMMING AND
OPERATION BY Symbolic FAPT, section 3.5 NC Data Preparation,
of the CONVERSATIONAL AUTOMATIC PROGRAMMING
FUNCTION FOR LATHE OPERATORs MANUAL,
B–61804E–2/04.
Primary machining NC data Secondary machining NC data
Primary
machining
process
Sub cycle process Sub cycle process
Secondary
machining
process
Identical sub cycle machining commands
are output on both NC data by setting ”0”
for the TURRET NO.(TL =0).
1.2.5
NC Data Preparation

Leave a Reply

Your email address will not be published. Required fields are marked *