Fanuc Symbol CAPi T Operators Manual

PROGRAMMING AND
OPERATION BY Symbolic FAPT
B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
58
On the blank figure input screen, the machining profile is initially
drawn as the blank figure.
Select the software key “CORRECTION” or LIST MODE and
“NEW” to prepare the blank figure referring to the machined figure
and to prepare it newly, respectively.
Similar to input of parts figure data, use a symbolic key for entry of
blank figure. In this case, however, “G”, “T” and “N” keys cannot be
used for parts figure difinition.
Input a blank figure according to any one of the following three
formats.
(a) Start or end point is on the coordinate axis.
(Example 1) (Example 2)
(Example 3)

Leave a Reply

Your email address will not be published. Required fields are marked *