Fanuc Symbol CAPi T Operators Manual

CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
B–63304EN/02
1. CAP II FOR TWO–PATH
LATHE WITH TWO
OPPOSING SPINDLES
760
NOTE
1 Machining time is not displayed for sub cycle process.
2 Motion of sub cycle process is not simulated in the
background animated simulation.
3 Process Editing Function is not available.
D Primary and secondary machining processes are simulated
simultaneously.
D Primary machining simulation is displayed on the left half of the
screen and secondary machining simulation on the right half of the
screen. (See Fig.1.2.6 (a) and Fig.1.2.6 (b))
D Only work piece and tool are drawn on the screen during the
simulation.
D During Caxis machining simulation, isometric perspective view is
shown in upper half of the primary and/or secondary machining
window, and Caxis front view or side view is shown in lower half of
the window.
D Following operations are performed on the work piece figures by
receiving corresponding Mcode from NC part program. Actual
M–codes are defined by the corresponding system parameters.
1) Restore original blank figure on the primary machining window.
(M–code defined by system parameter No.744)
(Work piece figure in the secondary machining window is not
deleted.)
2) Move work piece figure from the primary machining window to the
secondary machining window. (Mcode defined by system
parameter No.745)
(Work piece figure in the primary machining window is deleted.)
3) Delete work piece figure in the secondary machining window.
(M–code defined by system parameter No.746)
(Work piece figure in the primary machining window is not
deleted.)
D * MOVE WORK and COPY WORK softkeys are available for
moving or copying work piece figure from the primary machining
window to the secondary machining window.
1) By depressing the MOVE WORK softkey, the work piece
figure drawn on the primary machining window is moved to the
secondary machining window and the primary machining window
is erased. (See Fig.1.2.6 (c))
2) By depressing the COPY WORK softkey, the work piece figure
drawn on the primary machining window is duplicated on the
secondary machining window. (See Fig.1.2.6 (c))
D Tool position in the animated simulation picture can be switched
between upper side and lower side of the simulation window
according to the state of the system parameter No.705#1.
D Gradationally rendered 3D animation is available in gradation mode.
1.2.6
Animated Simulation
Function

Leave a Reply

Your email address will not be published. Required fields are marked *