Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. CAP II FOR TWOPATH
LATHE WITH TWO
OPPOSING SPINDLES
CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
763
(2)Tooling Information
Each of the primary and the secondary turret has its own tooling
information. When tooling a tool from the tool data to the primary
tooling information, geometry of the tool is copied as is. When tooling
a tool to the secondary tooling information, geometry of the tool is
reversed around Xaxis and copied.
NOTE
Tool geometry is reversed when system parameter No.800
#3 is set to “1”.
(3)Tool holder data
Both primary and secondary turret share common tool holder data.
When a tool holder is specified to be the holder for the secondary turret
tool, the tool holder is reversed around Xaxis when it is drawn on the
screen. The original tool holder data itself is not reversed. Refer to
chapter III, PROGRAMMING AND OPERATION BY Symbolic
FAPT, section 3.6.7 Setting of tool holder figure, of the
CONVERSATIONAL AUTOMATIC PROGRAMMING
FUNCTION FOR LATHE OPERATORs MANUAL,
B–61804E–2/04, for details.
NOTE
Tool holder geometry is reversed when system parameter
No.800 #3 is set to “1”.
Because tool geometry and tool holder geometry are not reversed
when system parameter No.800 #3 is set to “0”, care should be taken
to select tool and tool holder for the secondary turret.

Leave a Reply

Your email address will not be published. Required fields are marked *