Fanuc Symbol CAPi T Operators Manual

CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
B–63304EN/02
1. CAP II FOR TWO–PATH
LATHE WITH TWO
OPPOSING SPINDLES
764
No. Format Initial value Description Remarks
0206 Real
Undefined mm spec.
X–coordinate value of the home position (origin) of the
Number
Undefined inch spec.
primary turret.
Unit : mm or inch
0207 Real
Undefined mm spec.
Z–coordinate value of the home position (origin) of the
Number
Undefined inch spec.
primary turret.
Unit : mm or inch
0210 Real
Undefined mm spec.
X–coordinate value of the index position of the primary
Number
Undefined inch spec.
turret.
Unit : mm or inch
0211 Real
Undefined mm spec.
Z–coordinate value of the index position of the primary
Number
Undefined inch spec.
turret.
Unit : mm or inch
0216 Real
Undefined mm spec.
X–coordinate value of the home position (origin) of the
Number
Undefined inch spec.
secondary turret.
Unit : mm or inch
0217 Real
Undefined mm spec.
Z–coordinate value of the home position (origin) of the
Number
Undefined inch spec.
secondary turret.
Unit : mm or inch
0220 Real
Undefined mm spec.
X–coordinate value of the index position of the secondary
Number
Undefined inch spec.
turret.
Unit : mm or inch
0221 Real
Undefined mm spec.
Z–coordinate value of the index position of the secondary
Number
Undefined inch spec.
turret.
Unit : mm or inch
0705 0 or 1 00000000 Bit #1 In the animated simulation drawing;
0: Both primary and secondary tools are drawn on upper side
on the windows.
1: Both primary and secondary tools are drawn on lower side
on the windows.
Changed
0744 Integer Undefined M–code to restore original blank figure on the primary machining win-
dow.
JUser for animated machining simulationK
New
0745 Integer Undefined M–code to move work piece figure from the primary machining win-
dow to the secondary machining window.
JUser for animated machining simulationK
New
1.3
PARAMETERS
1.3.1
System Parameter

Leave a Reply

Your email address will not be published. Required fields are marked *