Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
1. CAP II FOR TWOPATH
LATHE WITH TWO
OPPOSING SPINDLES
CAP II FOR TWOPATH LATHE
WITH TWO OPPOSING SPINDLES
765
No. RemarksDescriptionInitial valueFormat
0746 Integer Undefined M–code to delete work piece figure in the secondary machining win-
dow.
JUser for animated machining simulationK
New
0800 0 or 1
(8 bits)
00001100
Bit 0 Define comments for arguments of a subcycle by;
0 : Alphanumeric characters.
1 : Character codes.
Bit 1 In the SUB CYCLE window under the “MACHINING
DEFINITION” window, POS.1 MACHIN softkey is;
0 : Not available.
1 : Available
Bit 2 In the SUB CYCLE window under the “MACHINING
DEFINITION” window, POS.2 MACHIN softkey is;
0 : Not available.
1 : Available
Bit 3 In the TOOLING INFORMATION window or the TOOL DATA
window under the MACHINING DEFINITION window, when
tooling tools onto secondary turret;
0 : Tool data and/or holder data is copied as is, without
reversing.
1 : Tool data and/or holder data is reversed around Xaxis and
copied.
Bit 4 In the SUB CYCLE window under the “MACHINING
DEFINITION” window, when arguments are left undefined;
0 : Addresses corresponding to undefined arguments are not
output in part program.
1 : Addresses corresponding to undefined arguments are
output in part program with the value of “0”.
7 6 5 4 3 2 1 0Bit
New
No. Format Initial value Description
1050 Integer 2 Number of turrets (1 or 2)
1: 2 axis lathe (1 spindle/1 turret or 2 spindle/1 turret)
2: 4 axis lathe (1 spindle/2 turret or 2 spindle/2 turret)
1055 Integer 2 Turret types
0: Ordinary 2 axis lathe
1: 2 axis lathe with reversible Xaxis (Chasing tool type turret etc.)
2: 4 axes lathe
1130 Integer 3 M–code for primary spindle CW (primary machining)
1131 Integer 4 M–code for primary spindle CCW (primary machining)
1132 Integer 5 M–code for primary spindle stop (primary machining)
1315 Integer –1 M–code for primary spindle milling start (primary machining)
1316 Integer –1 M–code for primary spindle turning start (primary machining)
1351 Integer 68 M–code for primary spindle Caxis clamp (primary machining)
1.3.2
MTF

Leave a Reply

Your email address will not be published. Required fields are marked *