Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
59
(b)Z axis coordinate values of start and end point are same.
(Example)
(c) Start and end point are same.
(Example)
(2)End of blank figure input
When all of blank figure has been input, key in the software key
“END” or “INPUT” if there is a question as shown below:
ELEMENT SYMBOL ES =. . . . . . . . .
The element figure created so far is redrawn and the following message
is displayed: Select software key
Press the NEXT PAGE if there are no areas modified and when
proceeding to the next process.

Leave a Reply

Your email address will not be published. Required fields are marked *