Fanuc Symbol CAPi T Operators Manual

SLANTED SURFACE MACHINING
B–63304EN/02
2. DEFINING PART
FIGURES (MENU NO. 2)
776
(3)On the detail data input screen for each figure type, pressing the
[SLANTED SURFACE SETTING] soft key displays the SLANTED
SURFACE SETTING screen.
ESCAPE BACK
PAGE
SLANTED
SURFACE
SETTING
CHECK
CURSOR
"
CURSOR
#
NEXT
PAGE
(For other than arbitrary slanted surfaces)
ESCAPE BACK
PAGE
SLANTED
SURFACE
SETTING
CHECK
CURSOR
"
CURSOR
#
NEXT
PAGE
(For arbitrary slanted surfaces: Screen for entering the start–point)
NOTE
No slanted surface can be specified for Yaxis end facing
figures.
(4)On the SLANTED SURFACE SETTING screen, set up the slanted
surface rotation center O (Z, DX), slant angle A, and safety height
from the slanted surface. Pressing the [END] soft key resumes the
previous detail data input screen.

Leave a Reply

Your email address will not be published. Required fields are marked *