Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
2. DEFINING PART
FIGURES (MENU NO. 2)
SLANTED SURFACE MACHINING
777
NOTE
1 The input range of slant angles can be specified using
system parameter Nos. 760 and 761.
2 If A = 0 is specified, a figure on a side surface, rather than
a figure on a slanted surface, is defined.
3 The entered safety height value must be 0 or greater.
4 Figures to be machined using even the second spindle are
entered with respect to the reference position on the
first–spindle side.
(5)On the detail data input screen, basically, the same method as for
Y–axis machining figures is used to enter the data about figures
machined on a slanted surface, except that a slanted surface (Y’Z’
plane) is involved. See the descriptions about Yaxis machining
figures for details.

Leave a Reply

Your email address will not be published. Required fields are marked *