Fanuc Symbol CAPi T Operators Manual

SLANTED SURFACE MACHINING
B–63304EN/02
2. DEFINING PART
FIGURES (MENU NO. 2)
778
Slanted surface machining figures can be checked using the following
procedure:
D On the YAXIS FIGURE menu screen, press [ALL CHECK] soft key.
D On the detail data setting screen, press the [CHECK] soft key.
Slanted surface machining figures are drawn as follows:
D The axes of the slanted surface coordinate system in the ZX plane are
drawn with solid lines.
D The position of figures on a slanted surface in the ZX plane is drawn
with dotted lines (for arbitrary figures, in the interpolation plane).
D Figures entered in the slanted surface coordinate system are drawn.
D The phase angle of the Caxis and the position of the Y’–axis of the
slante
d surface coordinate system are drawn.
2.2
CHECKING SLANTED
SURFACE
MACHINING
FIGURES

Leave a Reply

Your email address will not be published. Required fields are marked *