Fanuc Symbol CAPi T Operators Manual

SLANTED SURFACE MACHINING
B–63304EN/02
4. MACHINING DEFINITION
(MENU NO. 4)
786
Tool–change position
Rapid traverse
Cutting feed
G30 or G00
C1
SH
C1
C1
(2)Slanted surface contour machining
When approaching in slanted surface contour machining, the tool
moves from the toolchange position to the safe plane (interpolation
plane + safety height (SH) + clearance (C1) apart) at the rapid traverse
rate simultaneously with respect to the three axes (X, Y, Z). Then it
starts cutting at the cutting feedrate. Between figures, the tool moves
to the safe plane, then to the next figure, at the rapid traverse rate.
When escaping, the tool moves to the safe plane at the rapid traverse
rate, then return to the toolchange position by reference position
return or rapid traverse.
Tool–change position
Rapid traverse
Cutting feed
G30 or G00
C1
SH
Bit 1 of system parameter No. 309 is not referenced.
No efficiencyfirst mode is usable for slanted surface contour
machining (similarly to Yaxis machining).

Leave a Reply

Your email address will not be published. Required fields are marked *