Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
4. MACHINING DEFINITION
(MENU NO. 4)
SLANTED SURFACE MACHINING
787
On a machine tool in which the tool can be switched between normal and
reverse, setting bit 1 of system parameter No. 802 to 1 causes the
CLAMP DIRECTION prompt to appear on the TOOLING
INFORMATION setting screen, thus enabling you to select either normal
or reverse clamping.
Then, the clamp direction is displayed on the same line as for the “SET
ANGLE” prompt on the MACHINING DEFINITION TOOL DATA
setting screen for machining definition.
4.6
SETTING TOOL DATA
FOR MACHINING
WITH TOOL NORMAL
OR REVERSE
CLAMPING USED

Leave a Reply

Your email address will not be published. Required fields are marked *