Fanuc Symbol CAPi T Operators Manual

SLANTED SURFACE MACHINING
B–63304EN/02
6. ANIMATED SIMULATION
(MENU NO. 6)
798
If a single tool (such as a lathe drilling tool or milling tool) is used by
changing the slant angle of the tool angular axis or switching the tool
between normal and reverse clamping, using the same T code for all of
the different tool attitudes prevents a normal animated simulation of
machining figures.
In this case, a normal animated simulation of machining figures is enabled
by setting bit 3 of system parameter No. 802 to 1 and writing the M code
set in the following NC machine file before the T code.
In animated simulation of tool figures, the tool that matches the tool
attitude and orientation specified in the M code is selected from among
the tools for which the lowest two digits of the tool number specified in
the T code matches those of the tool number registered as tooling
information. This animated simulation is not performed unless a
matching tool has been registered as tooling information.
(NC machine file: M code output format)
No. Format Initial value Description
1420 5 Characters –1 Tool attitude 1 M code (for foreground animated simulation)
1421 5 Characters –1 Tool attitude 2 M code (for foreground animated simulation)
1422 5 Characters –1 Tool attitude 3 M code (for foreground animated simulation)
NOTE
The range of the M code values that can be entered is from
0 to 65535.
No. Format Initial value Description
1423 5 Characters –1 Turning tool orientation 1 M code (for foreground animated simulation)
1424 5 Characters –1 Turning tool orientation 2 M code (for foreground animated simulation)
NOTE
The range of the M code values that can be entered is from
0 to 65535.
Tool attitude 3 Tool attitude 1
Tool orientation 1 Tool orientation 2
Tool attitude 2
T01
T01
T01
T01 T01
X
Z
6.1
ANIMATED
SIMULATION FOR
DIFFERENT
MACHINING TYPES
PERFORMED WITH
THE SAME TOOL

Leave a Reply

Your email address will not be published. Required fields are marked *