Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
3. EXECUTION OF
Symbolic FAPT
PROGRAMMING AND
OPERATION BY Symbolic FAPT
63
When no corner is present for the machined figure or chamfering is
applied to all corners or no section to designate chamfering is present,
the chamfering screen is not selected even when the soft key
“CHAMFER” is depressed. For the machined figure composed of
many elements, even when the soft key “CHAMFER” is depressed,
the chamfer may not be entered.
(2)Corner R
The batch input function for corner R is similar to the batch input
function for chamfering. The function specifies identical corner R
data for corners whose chamfering data is left unspecified after the
entire machining profile is specified.
The batch input function for corner R cannot be used for 5700 series
of 16T CAP II.
After entering the turning figure, press the rightmost soft key [+].
Then, press the CORNER R key.
The yellow cursor lights at the corner whose chamfering data has not
yet been specified.
After entering the required data, press the EXEC soft key. The corner
R data is specified for the lighted corner. Then, the original screen is
displayed again.

Leave a Reply

Your email address will not be published. Required fields are marked *