Fanuc Symbol CAPi T Operators Manual

APPENDIX
B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
812
(1)Auto process setting data
Automatic process setting means that processes are determined by
setting data.
To specify setting data, press the DATA SET soft key on the initial
screen, enter 2, then press the INPUT key. Data items (except data 900
to data 902) are used to determine processes automatically. The
following table describes the setting data.
Data No. Format Initial value Description Remarks
0000 Integer 1 Selects a machining group (1 to 3).
1: Data items 100 to 166 in the 1st group are used.
2: Data items 200 to 266 in the 2nd group are used.
3: Data items 300 to 366 in the 3rd group are used.
If this value is not defined, one of the following groups is specified
according to the blank figure.
Round bar: Group 1
Drilled round bar: Group 2
Special blank: Group 3
0001 Real number Not defined Not used
0002 Real number Not defined Not used
0003 Real number 1 Drilling coefficient 1
When (drilling depth)/(drilling diameter) does not exceed the value of
data 3, a workpiece is machined in drilling method 1.
0004 Real number 101 Drilling coefficient 2
When (drilling depth)/(drilling diameter) is greater than the value of data
3 and does not exceed the value of data 4, a workpiece is machined in
drilling method 2. When (drilling depth)/(drilling diameter) is greater
than the value of data 4, a workpiece is machined in drilling method 3.
0005 Integer Not defined Not used
0010 Real number 3. Center drilling depth (D)
0011 Real number 0. Finishing width allowance for grooving (TW)
0012 Real number 0. Finishing depth allowance for grooving (TB)
0020 Real number 1. Coefficient 1 of Caxis drilling
When (drilling depth)/(drilling diameter) does not exceed the value of
data 20, a workpiece is machined in drilling method 1.
0021 Real number 101 Coefficient 2 of Caxis drilling When (drilling depth)/(drilling diameter)
is greater than the value of data 20 and does not exceed the value of
data 21, a workpiece is machined in drilling method 2.
When (drilling depth)/(drilling diameter) is greater than the value of data
21, a workpiece is machined in drilling method 3.
0022 Real number Not defined C–axis center drilling depth (D1)
0023 Real number 100. % of upperlimit for a prepared hole for Caxis tapping
0024 Real number 80. % of lowerlimit for a prepared hole for Caxis tapping
0030 to
0049
Integer Not defined Not used
0050 Real number Not defined Minimum inner surface diameter that can be machined Option B
0051 Real number Not defined Maximum diameter of a workpiece that can drilled Option B
A.1
SETTING DATA
TABLE

Leave a Reply

Your email address will not be published. Required fields are marked *