Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
813
Data No. RemarksDescriptionInitial valueFormat
0052 Real number Not defined Minimum drilling allowance Option B
0053 Real number Not defined Length–to–diameter ratio for the section to be drilled Option B
0054 Real number Not defined Coefficient for calculating the diameter of a prepared hole for C–axis
tapping (thread catch rate)
If this value is not defined, 1.082532 is specified.
Maximum prepared hole diameter
= D P C (value of data 22/100)
Minimum prepared hole diameter
= D P C (value of data 22/100)
D: Nominal diameter, P:
Pitch, C: Value of data 54
0055 to
0069
Real number Not defined Not defined
0070 Eight–digit
binary
00000000
Flags for multitier drilling
Bit 0 Method for drilling a hole having two or more tiers
0 : Multiple drilling in the order: minor diameter to major diameter
1 : Multiple drilling in the order: major diameter to minor diameter
Bit 1 Change of the tool selection method
0 : The effective tool selected by automatic process setting is used
for drilling.
1 : When the drill suitable for a machining diameter is not found in
tooling information or tool file, the input of the tool data is
requested on the tool data screen.
7
0
6
0
5
0
4
0
3
0
2
0
1 0Bit
Option B
0071 Eight–digit
binary
00000111
Flag for automatic setting of mirrorimage machining
Bit 0 End facing
Bit 1 Outer surface machining
Bit 2 Inner surface machining
0 : No mirrorimage machining is specified.
1 : Mirrorimage machining is specified.
Flag for outer surface finishing
Bit 7 When the following order is specified for the machining
procedure data: 1) End face finishing 2)
Outer surface finishing,
0 : Machining continues from end face to the outer surface when
the workpiece has an inner surface.
1 : The end face and outer surface are machined in separate
cycles when the workpiece has an inner surface.
7 6
0
5
0
4
0
3
0
2 1 0Bit
Option B
0072 Eight–digit
binary
00000000
Flag for automatic tool setting
Bit 0 Tooling information
Bit 1 Tool file
0 : Retrieved
1 : Not retrieved
7
0
6
0
5
0
4
0
3
0
2
0
1 0Bit
Option B
0073 to
0099
Eight–digit
binary
00000000 Not used

Leave a Reply

Your email address will not be published. Required fields are marked *