Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
815
Correspondence between settings and machining
Fro turning
1 : Center drilling 2: Drilling
2 : Drilling
3 : End facing roughing
4 : Outer surface roughing
5 : Inner surface roughing
6 : End face semifinishing
7 : Outer surface semifinishing
8 : Inner surface semifinishing
9 : End face finishing
10 : Outer surface finishing
11 : Inner surface finishing
12 : End face grooving
13 : Outer surface grooving
14 : Inner surface grooving
15 : Residual outer surface machining
16 : Residual inner surface machining
17 : Front face threading
18 : Outer surface threading
19 : Inner surface threading
20 : Cutting–off
21 : Bar feed
For C–axis machining
30 : End face center drilling
31 : Side face center drilling
32 : End face drilling
33 : Side face drilling
34 : End face tapping
35 : Side face tapping
36 : C–axis end face grooving
37 : C–axis side face grooving
38 : Front face milling
39 : Cylindrical grooving
NOTE
Be sure to specify that Caxis machining is executed after
turning finishing.

Leave a Reply

Your email address will not be published. Required fields are marked *