Fanuc Symbol CAPi T Operators Manual

B–63304EN/02
A. SETTING DATA,
SYSTEM PARAMETER, MTF
APPENDIX
817
Meaning of each flag
#7
0
#6
0
#5
0
#4
0
#3
0
#2
0
#1 #0
Bit 0 Specifies whether a tool is manually selected and whether the machining
start point and passing point are manually specified.
0 : The correct tool is automatically selected from the tooling
information.
1 : A tool is manually selected. The cursor temporarily stops moving
automatically to each field on the tool data screen, so the operator can
manually enter a tool number, machining start point, and passing
point.
Bit 1 Specifies whether cutting conditions are manually entered.
0 : Cutting conditions are automatically set.
1 : The cursor temporarily stops moving automatically to each field on
the cutting condition screen, so the operator can manually enter
cutting conditions.
Bit 2 Specifies whether a cutting direction and cutting area are manually
specified.
0 : A cutting direction and cutting area are automatically specified.
1 : The cursor temporarily stops moving automatically to each field on
the cutting direction and area screen, so the operator can manually
enter a cutting direction and cutting area.
(2)FAPT I/O interface data
Data No. Format Initial value Description Remarks
0900 Integer 1 Reader/punch interface number (1 to 3)
0901 Integer 10 Specifies a baud rate.
Setting
1 2 3 4 5 6
Baud rate
50 100 110 150 200 300
Setting 7 8 9 10 11
Baud rate
600 1200 2400 4800 9600
Option B
0902 Integer 2 Specifies the number of stop bits and the use of the DC code.
1: One stop bit and the DC code is used.
2: Two stop bits and the DC code is used.
5: One stop bit and the DC code is not used.
6: Two stop bits and the DC code is not used.

Leave a Reply

Your email address will not be published. Required fields are marked *